Multiple Choice
Identify the
choice that best completes the statement or answers the question.
|
|
|
1.
|
Adjust the drill press to the correct speed so the
drill bit .
a. | will not break | c. | will not overheat | b. | will remain straight | d. | will not make
noise |
|
|
|
2.
|
Be sure the tapered shank of the chuck or drill is
seated in the spindle so it
a. | will fall freely | c. | will not bcome too hot | b. | will not fall
out | d. | will not hold drill
bits |
|
|
|
3.
|
______________ leave a chuck key in the chuck
socket.
a. | periodically | c. | always | b. | sometimes | d. | never |
|
|
|
4.
|
Never hold small work __________ while
drilling.
a. | In a drill vise | c. | with your hands | b. | with a c clamp | d. | on the table |
|
|
|
5.
|
Clamp your material to the table or use a drill
press vise to keep the work from
a. | turning | c. | burning | b. | reversing | d. | sliding |
|
|
|
6.
|
_____________stop revolving work by grabbing it.
Turn off the machine and step away.
a. | periodically | c. | always | b. | sometimes | d. | never |
|
|
|
7.
|
Ease the pressure of the _________ as the drill
breaks through the bottom side of your work.
a. | feed | c. | column | b. | clamp | d. | table |
|
|
|
8.
|
Large drills should be run .
a. | fast speeds | c. | on larger drill presses only | b. | slow speeds
| d. | at any
speed |
|
|
|
9.
|
When using the drill press
a. | stay very close to the spindle | c. | have another student assist
you | b. | loose clothing is not a hazard | d. | do not lean close to the
spindle |
|